BMW R1200RT/R1250RT Forum

its the actual cylinder to head gasket in question. 

I have a 2014 wet head 1200RT that I have a new head gasket to put on.  Is there a right or wrong side to put it on?  It has a BMW part marking on one side, other than that I can't find anything on if it makes any difference or not.
    thanks!!!!

I have/had a 2014 wet head 1200rt that just recently busted a right side lower exhaust spring.  Yes you read it right, it did.  I babied that thing to.  It red lines 9 grand and I don't think it ever seen even 5 grand.  Anyway, the valve looks like it took out the...

I though of that too, and no staring the engine has no effect.  I don't have wireless, and I also thought I remembered the beam was on demand.  So I started it in the garage with door all down and dark.  Still does the same thing.

I have a 2015 R1200RT wet head with a low beam headlight issue. The center (low beam) went out on me and I replaced it with a Sylvania H7 silverstar bulb. after many hours of the most excruciating time I haver ever spent... might I digress.. It didn't come on . So, in the middle of preparation for H...

Does anyone know of a good on line source (parts house) to buy BMW parts from?

well after closer inspection, when they changed the tire the sensor ring got bent back quite a bit somehow.  I took the tire off again and took the ring off and between a few friends, it looks a lot better than it for sure.  (until I can get a new one)  I put it back on bu...

I just changed the front tire on my 2014 1200rt. On the first roll out of the garage I noticed I didn't have any front break.  After pumping the brake a few times it seem to come back ok. I then started out and the bike felt like it wanted to buck..just a few times then it quit and soothed ...

My 2014RT tire pressure monitor for both the front and rear tires is reading about 9 to pounds lower than the actual pressure.  The problem is that the bike seems to give a display warning if it reads lower than about 32 pounds. I don't want to overinflate just to clear the warning.&nbs...

I seem to have very poor FM radio reception as on my 2014RT.  I took the top covers off to look down in the abyss, and found what looked to be an unshielded  bradded  wire connection to the antenna...not a solid RG type I was expecting..Is that right?  You say by ...

yes, I took a short 3 mile ride, still dashes for pressure.  Its a nice problem, looks like maybe a trip to the dealer.  If one tire was reporting in I could be pretty sure what the problem was, but neither one here.  I think  maybe a failure to communicate with t...

Just changed my rear tire one 2014 1200rt and I went to check the tire pressure on the display and its not showing either the front or the rear psi.  I was careful not to smash or pry on the sensor.  I did change the screw in valve on the mag spoke ( the inside valve was not screwi...

Maybe I am not making myself clear.  Its for backrest mounting for like these guys.  http://www.bakupusa.com/bmw_models.html 

I was looking at backrests for the driver. Can anyone tell me if the bolt pattern for mounting these (under the seat)  for a 2014 1200rt is the same as the 2013 model?

That video did it!!  my SENA paired up...took a bit to find it, but it did and its working great!!  THANKS!!