Grip Puppies installation question

General discussion of the BMW R1200RT/R1250RT
Post Reply
Methos1979
Posts: 90
Joined: Sun Jul 03, 2016 5:28 pm

Grip Puppies installation question

Post by Methos1979 »

Just got some new Grip Puppies and they seem like they might be a little long, like a half inch. For those that have installed these did you trim them to size first or just squish them on?

Sent from my SM-N900V using Tapatalk

T6pilot
Posts: 574
Joined: Sat Jun 27, 2015 6:12 am
Been liked: 1 time

Re: Grip Puppies installation question

Post by T6pilot »

Trimmed before install
Jim
falconmick
Posts: 92
Joined: Tue Mar 22, 2016 9:47 pm

Re: Grip Puppies installation question

Post by falconmick »

Trim and then use washing up liquid or  hair lacquer to help them into place.
Peter Baker
Posts: 181
Joined: Tue Dec 22, 2015 11:23 pm
Location: Somerset
Has liked: 14 times
Been liked: 6 times
Great Britain

Re: Grip Puppies installation question

Post by Peter Baker »

Yes cut to length, having done a couple of them now on various bikes I tend to error cutting them too long the first time as you can always trim them again...  Peter
Methos1979
Posts: 90
Joined: Sun Jul 03, 2016 5:28 pm

Re: Grip Puppies installation question

Post by Methos1979 »

Thanks to all. Trimmed them to size, installed in minutes, test rode for two hours and promptly cut them off. They my hand go numb faster! Who knew?
Nobby
Posts: 44
Joined: Sun Mar 27, 2016 7:18 pm

Re: Grip Puppies installation question

Post by Nobby »

I only cut the one on the RHS to make sure it didn't stop the mechanism working properly.
Stratman
Posts: 44
Joined: Mon May 09, 2016 3:26 pm

Re: Grip Puppies installation question

Post by Stratman »

I fitted some the other weeks and they stopped all the tingling/numbness, even after a 5 hour ride.
Casbar
Posts: 2670
Joined: Wed Jan 27, 2016 6:25 am
Been liked: 45 times
Great Britain

Re: Grip Puppies installation question

Post by Casbar »

Stratman wrote: I fitted some the other weeks and they stopped all the tingling/numbness, even after a 5 hour ride.

They defiantly helped with my tingling fingers. I found that if you move your grip on the throttle a little out, it helps a lot, and I only get tingling in at certain revs. I never have an issue with the left grip, just the throttle. They have helped a lot and if I move my grip and don't grip to tight they are fine
User avatar
MacJ
Posts: 153
Joined: Sun Feb 28, 2016 9:16 am

Re: Grip Puppies installation question

Post by MacJ »

I followed the tip I found on the forum and bought a couple of rolls of Dunlop Raquet Handle tape. (£2.79 a roll at Sports Direct) Its nicely padded and self adhesive. With a bit of care( and a few dry runs) you can get a really nice finish. It makes the grips that much fatter and reduces any vibes.


I haven't tried whacking any balls with the handlebars though! ;)
User avatar
Simon
Posts: 24
Joined: Mon Feb 29, 2016 4:48 pm

Re: Grip Puppies installation question

Post by Simon »

Always painful to whack balls with the handlebars! 
2010 R1200RT SE - The Silver Machine
Post Reply