Page 1 of 1
Extra brake lamp.
Posted: Sun Jan 23, 2022 6:16 pm
by Doctor T
Hi, I want to fit an extra brake lamp under the number plate. It's a 2007 model. The lamp is LED and am thinking of tapping into the rear light wires.
Will the cambus be affected each time i brake?. I've never fitted extra lights on a cambus bike before so i thought of asking the knowledgeable people on here first before i go soldering wires.
Re: Extra brake lamp.
Posted: Tue Jan 25, 2022 12:57 am
by Randyjaco
I was able to do it on my ST, so it will probably work. Let us know if it works on yours. I am planing to do the same on my RT
Re: Extra brake lamp.
Posted: Tue Jan 25, 2022 9:52 am
by David.
Doctor T wrote:Will the CAN-bus be affected.
Understanding The BMW Motorcycle CANBUS System,
Understanding The BMW Motorcycle CANBUS System - YouTube
Re: Extra brake lamp.
Posted: Tue Jan 25, 2022 9:57 am
by David.
Doctor T wrote:Before I go soldering wires.
The brake lamp bulb holders have spade connections, could always use these.
Re: Extra brake lamp.
Posted: Fri Jan 28, 2022 2:32 pm
by Doctor T
Cheers David. I subscribe to Tinderboxarts on YT but i missed this one.
Re: Extra brake lamp.
Posted: Fri Jan 28, 2022 2:46 pm
by Randyjaco
I got my modulated brake light and started to install it yesterday. I stopped upon noteing how much Tupperware that had to be removed in order to get to the brake light. My new RT is fast becoming my least favorite motorcycle to work on. I am just going to wait until I do my annual service. B^(
I will be looking forward to hear about your success
Re: Extra brake lamp.
Posted: Sat Nov 19, 2022 7:21 am
by Marvin2Shoes
No tupperware on the 2011 model (they couldn'tbethat much different could they?)... just two screws, one on either side of the tail light housing on the 2011 model....
- 20221119_171816.jpg (273.97 KiB) Viewed 397 times
Re: Extra brake lamp.
Posted: Sat Nov 19, 2022 8:00 pm
by michaelc2710
It should be fine, just like fitting a topbox brake light which are LED.