Hello everyone!
I recently acquired a Vantrue Falcon F1 dash cam and am looking to install it on my 2023 R1250 RT. I would greatly appreciate if anyone could share their experiences or tips related to this setup. Previously, I have installed Clearwater lights on this bike, including the Billie brake light, although I found it quite challenging in spite of their clear instructions. But in the end I'm satisfied that I did a good job.
For the dash cam installation, I am specifically interested in the following:
1. Optimal locations for mounting the front camera.
2. Suggestions for placing the control unit, especially considering the limited space under the seat and the need for effective heat dissipation.
3. Advice on where and how to connect to the ACC switched power wire.
4. Any other installation tips you might have.
I've previously installed a very basic dashcam on my 2011 RT, which was a fun project. Given the advancements in technology and quality, I'm eager to see how the Falcon F1 performs.
Thank you in advance for your help!